Achronix ACE Version 5.0 Manuel d'utilisateur télécharger pdf (Page 208)

Dialogs Chapter 3. Concepts

Add Signals to Waveform Viewer Dialog

This dialog allows the user to add signals to the table and waveform area of the VCD Waveform Editor. The

dialog allows the user to either unhide signals which were previously hidden via the Remove button in the

VCD Waveform editor, or add duplicates of already-shown signals to the table and waveform. The selected

signals may added at either the top or bottom of the table/waveform via the dialog. If the user wishes to

move the signals to a location other than the top or bottom, this must be done via the Move Up and Move

Down buttons on the VCD Waveform editor.

Figure 3.108: Add Signals to Waveform Viewer Dialog

The majority of the dialog is taken up by an area listing the signals. The signals listed will vary depending

upon the radio-button currently selected in the dialog.

Add Signals to Waveform Viewer Dialog Actions

Action

Description

Select from All

Signals

When selected, this radio button will cause the list to be populated with all the

signals contained in the current VCD ﬁle.

Select from

Hidden Signals

When selected, this radio button will cause the list to be populated with all the

signals found in the VCD ﬁle which are currently hidden. (Signals ’removed’ from

the VCD Waveform editor’s signal table are considered hidden.) If no signals are

currently hidden, the list of hidden signals will be empty.

Append

This button appends the currently-selected signal to the bottom of the VCD

Waveform Editor’s signal table.

Insert

This button inserts the signal currently selected in the dialog’s list below the signal

currently selected in the VCD Waveform Editor’s signal table. If no signal was

selected in the VCD Waveform Editor’s signal table when the Add. . . button was

pressed to bring up this dialog, the signal selected in the dialog is inserted at the top

of the VCD Waveform Editor’s signal table.

This button closes the dialog.

Note:

UG001 Rev. 5.0 - 5th December 2012 http://www.achronix.com 196

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 388 389

Pas de commentaire

Achronix ACE Version 5.0 Manuel d'utilisateur Page 208